Used for automotive electrical installation measurements without stripping the wires insulation
The application of this automotive needle probe set is to helps for measurements on the automobile electrical installation without damaging the entirety of the wires insulation.
The main use is for back pinning probe of the electrical connectors. It is made by means of their piercing through moisture-proof and dustproof rubber seals of the wires from the rear side of the coupling. Based on the routine it is recommended these seals to be pulled back in advance to avoid their piercing during the manipulation.
The automotive needle probe set consists in 4 mm female banana plug and fine steel needle. The smallest diameter of the needle is the most important to keep safe the fragile connector.
Do not neglect the fact that together with the probe set we place at your disposal also lots of replacement needles. If some needle becomes damaged, worn or broken, there is no need to buy a whole new back-probe, simply take the appropriate hexagonal screwdriver, unscrew the small bolt inside the female banana plug and replace the needle with the new one.
And finally with this product most of the problems associated with traditional back-pinning methods can be solved.